主要组成 Main composition | 用酚醛漆料与各色颜料，防锈颜料、体质颜料、消光粉等经混合研磨后加入催干剂调制而成。 It is made of phenolic paint and various pigments, antirust pigments, physical pigments, matting powder, etc., after mixed grinding and adding driers. | |
主要特性Main characteristics |
自干性漆，漆膜对铁线具有良好的附着力、遮盖力和防锈性能，光泽柔和。 Self-drying paint, paint film has good adhesion, hiding power and anti-rust performance, soft gloss. | |
主要用途 Main use | 铁艺制品的装饰性涂装。 Decorative painting of iron products. | |
基本参数 Basic parameters | 干燥时间（25℃） Drying time (25 ℃) | 表干：≤3 小时，实干：≤24 小时。 Table dry: ≤ 3 hours, practical work: ≤ 24 hours. |
光泽，% Luster,% | 半光：20～50，哑光：≤10。 Semi-light: 20: 50, matte: ≤ 10. | |
表面处理Surface treatment |
被涂刷表面应无水、无油、无污物等。 The brushed surface should be free of water, oil, dirt, etc. | |
复涂间隔时间 Interval time of recoating |
1～2 道，或视具体情况而定。 1-2 channels, or depending on the specific situation. | |
建议涂装道数Recommended number of painting lines |
20～24 小时。20 to 24 hours. | |
施工参考Construction reference | 可刷涂或喷涂，使用前需将油漆充分搅匀，如粘度过大，用200#溶剂汽油或少量松节油兑稀，如有漆皮和粗颗粒， 必须过滤方能使用，每道漆涂刷不能太厚，以免漆膜起皱或影响实干，需要复涂几道的，应等前道漆膜干透后再涂下道漆。 Can be brushed or sprayed, the paint should be fully stirred before use, if the viscosity is too high, use 20g solvent gasoline or a small amount of turpentine to dilute, if there are lacquer skin and coarse particles, must be filtered before use, each paint brush can not be too thick, lest the paint film wrinkles or affect the actual dry, need to reapply several lines, should wait for the previous paint film to dry before painting. | |
储藏期限 Storage period | 产品在规定储运条件下，漆料储存期为12 个月，超过储存期可按质量标准检验，如符合技术要求，仍可使用。Under the specified storage and transportation conditions, the storage period of paint is 12 months, which can be inspected according to the quality standard after the storage period. If it meets the technical requirements, it can still be used. | |
附注：本说明书有关数据是在标准条件下实验取得，实际使用时，因环境条件和施工方法的差异可能与之略有不同，以上数据如有改变，已本厂最新说明书为准，恕不另行通知。 Note: the relevant data in this manual are obtained by experiment under standard conditions. In actual use, they may be slightly different due to differences in environmental conditions and construction methods. If the above data are changed, the latest instructions of our factory will prevail without prior notice. | ||